EnCata and MakIT Center run a toturial session for UNDP project

Jul 2019

EnCata and MakIT Center run a toturia session for UNDP project “Support for local economic development in the Republic of Belarus”.

We welcomed the participants and made a masterclass on innovation and hardware development process at our MakeIT Center hackerspace.

Back to all NEWS

EnCata's insights

Product development

Engineering

10 things we usually redo in startups’ CAD models before manufacturing

Learn the 10 most common product design mistakes that threaten manufacturability. This article is brought to you by EnCata’s Business Development specialist Pavel Avramenko.

Product development

Engineering

5 Things to Consider Before Plastic Injection Molding: Aluminum vs. Steel

Learn the difference between steel and aluminum molds while manufacturing injection molded parts. The guide for saving budget, time and enhancing plastic molding quality

Hardware Development

Engineering

7 things to do before starting IoT product prototyping

The article fleshes out the steps that a product owner must go through before prototytping. In this post, brought to you by our Head of Electronics Design Department Dmitriy Kremez, you will figure out what to do next if you have a device mockup.

Product debvelopment

Prototyping

Engineering

3D printing VS. injection molding: technologies for success. Part 2

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Suspendisse varius enim in eros elementum tristique. Duis cursus, mi quis viverra ornare, eros dolor interdum nulla, ut commodo diam libero vitae erat. Aenean faucibus nibh et justo cursus id rutrum lorem imperdiet. Nunc ut sem vitae risus tristique posuere.